Conair 50, 25, 15, 100 specifications A d j u s t i n g t h e L i m i t S w i t c h

A d j u s t i n g t h e L i m i t S w i t c h

1Stop the dryer. Disconnect and lockout the main power.

2 Remove the right side panel from the dryer.

IMPORTANT: Note the position of the tanks.

6 - 2 0 l Tr o u b l e s h o o t i n g

3Loosen the screws securing the limit switch to the carousel. Note that the hole for the front screw is slotted to allow for adjustment.

4Slide the switch to the left or right to position the limit switch so that its small roller drops into the valley on the bed plate. The roller on the switch should not hit the stationary bottom plate.

5Test for correct indexing of the carousel. Restore main power to the dryer. Hold the limit switch out of the valley on the carousel bed plate while you push START. It may not be necessary to push START. If not in run mode, the carousel will turn when the switch is out of the valley. Once the bed plate starts turning, release the switch.

If everything is adjusted correctly:

•The carousel bed turns.

•When the limit switch reaches the next valley in the bed plate, the carousel should stop turning.

6Reset the desiccant carousel.

Continue indexing until the desiccant tanks return to the positions they were in when the dryer shut down.