Cub Cadet 7530 Hydraulic Filter Gear & Hydrostatic Drive, Change the Hydraulic Filter AS Follows

LUBRICATION/FILTERS/FRUIDS

Hydraulic Filter (Gear & Hydrostatic Drive)

Change Interval

NOTE: Replace the hydraulic filter after the first 50 hours of operation and every 200 hours of operation thereafter. Your Dealer has approved genuine filters. Do not use other type filters.

Every 200 hours (See NOTE)

HYDRAULIC FILTER

CHANGE THE HYDRAULIC FILTER AS FOLLOWS:

1.Put the tractor on level ground, move the range shift lever to the L position and apply the park brake.

2.Put an oil canister under the hydraulic filter.

3.Turn the filter counterclockwise to remove. Use a filter wrench if necessary.

4.Apply clean oil to the O-ring on the new filter.

5.Install the filter. Turn the filter until the O-ring comes in contact with the case surface. Tighten the filter an additional 2/3 turns by hand.

IMPORTANT: DO NOT use a filter wrench to install the hydraulic filter. When the filter is too tight, you can cause damage to the O-ring and filter.

6.Wipe around the hydraulic filter with a dry cloth.

7.Change the transmission oil. See Transmission Oil Change in this manual.

100