OPERATING INSTRUCTION
POWER TAKEOFF (PTO)
PTO driven machinery can cause serious injury or death, usually due to wrapped clothing. When required by the job to be in the drive shaft area, stay clear of rotating parts. Before working on the drive shaft, or servicing or clearing the driven machine, where applicable on this tractor, put the PTO clutch lever in the DISENGAGE position, the PTO lever in the NEUTRAL or OFF, and STOP the engine.
Rear PTO (HST)
The rear PTO is a 540 RPM with a
34.9mm (1 3/8 inch) diameter 6 spline output shaft.
ENGAGE THE REAR PTO AS FOLLOWS:
REAR PTO SHAFTE
1.Push the clutch pedal fully.
2.Move the PTO control lever to the ON position.
3. Release the clutch pedal slowly.
DISENGAGE THE REAR PTO | CLUTCH PEDAL |
| |
AS FOLLOWS: | CLUTCH PEDAL |
|
1.Push the clutch pedal fully.
2.Move the PTO control lever to the OFF (Engine Start) position.
NOTE : Keep the PTO control lever |
|
in the OFF (Engine Start) position |
|
when starting the engine and when REAR PTO | |
the PTO is not being used. | CONTROL LEVER |
| |
3. Release the clutch pedal slowly.
The following table shows the required speed to get the required Rear PTO output shaft speed.
PTO Output Shaft Speed
Required
Engine Speed
540 RPM
2376 RPM
49
