ELECTRICAL SYSTEM
WARNING
B AT T E R I E S C O N TA I N A C I D A N D E X P L O S I V E
G A S . E X P L O S I O N C A N R E S U LT F R O M
S PA R K S , F L A M E S , O R W R O N G C A B L E C O N -
N E C T I O N S . TO C O N N E C T J U M P E R C A B L E S
O R C H A R G E R , S E E M A N U A L ( S ) F O R T H E
C O R R E C T P R O C E D U R E . FA I L U R E TO
F O L L O W T H E A B O V E I N S T R U C T I O N S C A N
C A U S E S E R I O U S P E R S O N A L I N J U RY O R
D E AT H
3 2 1 - 6 7 1 4
Battery Cables and Terminals
The battery Terminals must be kept clean and tight. A good method to clean terminals is to use Battery Saver. If Saver is not available, remove all corrosion with a wire brush, then wash with a weak solution of baking soda or ammonia. Put some petroleum jelly or light grease on terminals to prevent corrosion.
Removal and Installation of Battery
To remove the battery, disconnect the battery cables and remove the battery bracket. When the battery is installed, make sure the cables are installed on the correct terminals. This is a
NOTE: When disconnecting the battery, remove the negative cable first from the battery and reconnect it last for safety reasons.
IMPORTANT: Do not start or operate the engine with the electrical system not completely connected.
115
