Transmission Oil Change
Oil Change Interval
To change the transmission oil, use the following procedure:
1.Put the tractor on level ground, apply the park brake and stop the engine. Move the range shift lever to L position.
2.Remove the drain plugs from the
transmission case. (5 )
NOTE: For best results, drain the oil when the oil is warm.
3.Replace the hydraulic filter. See Hydraulic Filter in this manual.
4.For the hydrostatic drive tractor, replace hydrostatic filter, See Hydrostatic Filter (Hydrostatic Drive) in this manual.
5.Install the drain plugs with a seal washer and tighten to a torque of 39 to 44 Nm (29 to 33 lb ft).
6.Add the recommended oil through the fill hole and check the oil level.
7.Start the engine and check for leaks.
8.Recheck the oil level after stopping the engine. If the oil level is low, add oil up to the specified level.
LUBRICATION/FILTERS/FRUIDS
Every 200 hours
TRANSMISSION DRAIN PLUG
TRANSMISSION DRAIN PLUG
FILL HOLE
GEAR DRIVE
FILL HOLE
HYDROSTATIC DRIVE
99
