Chapter 4: Command Line Interface

45

 

 

Examples

To check the hardware overcurrent status of IPDU #1, enter the following.

pm>hwocp 1

IPDU #1: HW overcurrent protection is OFF.

To reset the hardware overcurrent protection, enter the following.

pm>hwocp 1 reset

IPDU #1 was reset

id

The id command sets or displays the ID of a PM IPDU. A maximum of 16 characters (not case sensitive) is allowed. Spaces, numbers, and special characters are allowed. This command is available to the administrator user only.

This command works in a daisy chain.

Syntax

id [<IPDU#>] [<IPDU_ID>]

-or-

id [<IPDU_ID>] [<IPDU_ID>]

-or-

id

Arguments

<IPDU#> IPDU number in a daisy chain

<IPDU_ID> Identification string previously set by the id command

If <IPDU_ID> follows <IPDU#>, or if the <IPDU_ID> parameter is typed twice, the latest entry of the <IPDU_ID> parameter updates the ID string.

no argument Displays the IDs of all PM IPDUs in the daisy chain

Examples

To set the ID of PM IPDU 1 R&D, enter the following.

pm>id 1 R&D

IPDU #1: id = R&D

Page 57
Image 57
Cyclades PM IPDU manual To set the ID of PM Ipdu 1 R&D, enter the following, Pmhwocp 1 reset, Pmid 1 R&D