DGS-3024 Gigabit Ethernet Switch Manual
Figure 9- 11. SNMP Community Table Configuration window
The following parameters can be set:
Parameter Description
Community Name | Type an alphanumeric string of up to 32 characters that is used to identify members of |
| an SNMP community. This string is used like a password to give remote SNMP |
| managers access to MIB objects in the Switch's SNMP agent. |
|
|
View Name | Type an alphanumeric string of up to 32 characters that is used to identify the group of |
| MIB objects that a remote SNMP manager is allowed to access on the Switch. The |
| view name must exist in the SNMP View Table. |
|
|
Access Right | Read Only – Specifies that SNMP community members using the community string |
| created can only read the contents of the MIBs on the Switch. |
| Read Write – Specifies that SNMP community members using the community string |
| created can read from, and write to the contents of the MIBs on the Switch. |
|
|
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table, click the 
under the Delete heading, corresponding to the entry you wish to delete.
SNMP Host Table
Use the SNMP Host Table window to set up SNMP trap recipients.
Open the SNMP Manager folder, located in the Management folder and click on the SNMP Host Table link. This will open the SNMP Host Table window, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding 
under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host IP Address heading.
113
