DGS-3024 Gigabit Ethernet Switch Manual
Figure 10- 11. Tx Error Analysis window (table)
The following fields may be set or viewed:
Parameter | Description | ||
|
|
|
|
Time Interval |
| Select the desired setting between 1s and 60s, where "s" stands for seconds. The |
|
|
| default value is one second. |
|
|
|
|
|
Record Number |
| Select the number of times the Switch will be polled between 20 and 200. The default |
|
|
| value is 20. |
|
|
|
|
|
ExDefer |
| Counts the number of packets for which the first transmission attempt on a particular |
|
|
| interface was delayed because the medium was busy. |
|
|
|
|
|
LateColl |
| Counts the number of times that a collision is detected later than 512 |
|
|
| transmission of a packet. |
|
|
|
|
|
ExColl |
| Excessive Collisions. The number of packets for which transmission failed due to |
|
|
| excessive collisions. |
|
|
|
|
|
SingColl |
| Single Collision Frames. The number of successfully transmitted packets for which |
|
|
| transmission is inhibited by more than one collision. |
|
|
|
|
|
Coll |
| An estimate of the total number of collisions on this network segment. |
|
|
|
|
|
CRCError |
| Counts otherwise valid packets that did not end on a byte (octet) boundary. |
|
|
|
|
|
Show/Hide |
| Check whether or not to display ExDefer, LateColl, ExColl, SingColl, Coll, and CRC |
|
|
| errors. |
|
|
|
|
|
Clear |
| Clicking this button clears all statistics counters on this window. |
|
|
|
|
|
126
