D-Link DSL-G604T manual Flow Control, Learning

DGS-3024 Gigabit Ethernet Switch Manual

	then to use those settings. The other options are 10M/Half, 10M/Full, 100M/Half
	and 100M/Full, 1000M/Full_M and 1000M/Full_S. There is no automatic
	adjustment of port settings with any option other than Auto.
	The Switch allows the user to configure two types of gigabit connections;
	1000M/Full_M and 1000M/Full_S. Gigabit connections are only supported in full
	duplex connections and take on certain characteristics that are different from the
	other choices listed.
	The 1000M/Full_M (master) and 1000M/Full_S (slave) parameters refer to
	connections running a 1000BASE-T cable for connection between the Switch port
	and other device capable of a gigabit connection. The master setting
	(1000M/Full_M) will allow the port to advertise capabilities related to duplex, speed
	and physical layer type. The master setting will also determine the master and
	slave relationship between the two connected physical layers. This relationship is
	necessary for establishing the timing control between the two physical layers. The
	timing control is set on a master physical layer by a local source. The slave setting
	(1000M/Full_S) uses loop timing, where the timing comes form a data stream
	received from the master. If one connection is set for 1000M/Full_M, the other
	side of the connection must be set for 1000M/Full_S. Any other configuration will
	result in a link down status for both ports.
Flow Control	Displays the flow control scheme used for the various port configurations. Ports
	configured for full-duplex use 802.3x flow control, half-duplex ports use
	backpressure flow control, and Auto ports use an automatic selection of the two.
	The default is Disabled.
Learning	Enable or disable MAC address learning for the selected ports. When Enabled,
	destination and source MAC addresses are automatically listed in the forwarding
	table. When learning is Disabled, MAC addresses must be manually entered into
	the forwarding table. This is sometimes done for security or efficiency reasons.
	See the section on Forwarding for information on entering MAC addresses into the
	forwarding table. The default setting is Disabled.

Click Apply to implement the new settings on the Switch.

27