|
|
|
|
|
|
| Frame Type | This field denotes the type of frame that will be accepted by the port. The user may |
|
| choose between Tagged Only, which means only VLAN tagged frames will be |
|
| accepted, and Admit_All, which means both tagged and untagged frames will be |
|
| accepted. Admit_All is enabled by default. |
|
|
|
| PVID | This field in the 802.1Q Port Table shows the current PVID assignment for each |
|
| port, which may be manually assigned to a VLAN when created in the 802.1Q Port |
|
| Settings table. The Switch's default is to assign all ports to the default VLAN with a |
|
| VID of 1.The PVID is used by the port to tag outgoing, untagged packets, and to |
|
| make filtering decisions about incoming packets. If the port is specified to accept |
|
| only tagged frames - as tagging, and an untagged packet is forwarded to the port for |
|
| transmission, the port will add an 802.1Q tag using the PVID to write the VID in the |
|
| tag. When the packet arrives at its destination, the receiving device will use the |
|
| PVID to make VLAN forwarding decisions. If a packet is received by the port, and |
|
| Ingress filtering is Enabled, the port will compare the VID of the incoming packet to |
|
| its PVID. If the two are unequal, the port will drop the packet. If the two are equal, |
|
| the port will receive the packet. |
|
|
|
| GVRP | The Group VLAN Registration Protocol (GVRP) enables the port to dynamically |
|
| become a member of a VLAN. GVRP is Disabled by default. |
|
|
|
Click Apply to implement changes made.
SNTP Settings
Time Setting
To configure the time settings for the Switch, open the Configuration folder, then the SNTP Settings folder and click on the Time Setting link, revealing the following window for the user to configure.
59
