
STX e Select Edge Sensor
This command enables transmissive
Syntax:<STX>e
Note: This command is ignored when <STX>cnnnn is issued with a
STX F | Form Feed |
This commands the printer to form feed to the next start of print.
Syntax:<STX>F
Printer response: | The printer will form feed. |
Note: Following a reset, if the length of the first label fed is less than the label offset value (defined by the <STX>O command) the printer will advance past that label until a
STX f Set Form Stop Position (Backfeed Command)
This sets the stop position of the printed label, allowing the label to stop at a point past the
Syntax:
Where:
<STX>fnnn
nnn- Is a
Sample:<STX>f230
The sample sets a stop position distance of 230 (2.3 inches from the Media Sensor’s eye).
STX G Print Last Label Format
This command prints a previously formatted label and restarts a canceled batch job following the last processed label. This is used when there is a label format in the buffer. The <STX>E command is used to enter the quantity. (If the <STX>E command is not used only one label will print.)
Syntax:<STX>G
14 |