Extended System Commands

S

Set Slew Speed

This command controls the rate at which the label is moved through non-printed areas. The setting remains unchanged unless another slew speed command is received or until the printer is reset.

Syntax:

Where:

Sample:

Sa

a- Is a single alpha character representing a speed; see Appendix K for valid ranges.

<STX>L

SE 141100001000100LABEL1<CR>

E <STX>L 1411000010001000LABEL2<CR>

E

The sample sets the slew speed to 3 inches per second (76 mmps), and prints two labels. The slew speed for the second label is the same as the first.

s

Store Label Format In Module

This command stores a label format to a specified module. Supplying the module name (see Appendix J for valid designators) will store the label to that module; otherwise, using C will cause the label format to be stored in the selected default module (see <STX>X.). In addition, this command terminates the Label-Formatting Command.

Syntax:

Where:

Sample:

Sann…n

a- Is the module designator representing a single character module name; see Appendix J.

nn…n - Represents the name of the label (maximum 16 characters).

<STX>L<CR>

D11<CR>

191100501000000123456789012<CR>

1911005020000001234567<CR>

191100500000000Sample<CR>

1X1100000000000B250250002002<CR>

Q0001<CR>

sATEST<CR>

The example stores a format in memory module A and names it ‘TEST’. (To recall a label format from the module use the ‘r’ command.)

E-Class DPL Programmer’s Manual

49

Page 59
Image 59
Datamax E4203 manual Set Slew Speed, Store Label Format In Module