Section 3 | Configuring the DriveRack™ | DriveRack | ™ |
|
| | |
B modules. Note that the same EQ types must be selected to link. Use the PREV PG and NEXT PG buttons to move through A and B, and then to the next module screen which will appear something like this:
•You are now in the Pre-Crossover Insert module. The arrow (in correspondence with the Module 1 or 2 indicators, along with the A and B indicators indicate which module block is currently selected. Rotate the DATA wheel to select either Wire, AGC, Compressor, AFS, Noise Gate or Subharmonic Synthesizer. Pressing and then rotating the DATA wheel lets you link or unlink the A and B modules. Note that the same Effect types must selected to link. Use the PREV PG and NEXT PG buttons to move through A and B, 1 and 2 and then to the next module screen which will appear something like this:
MONO DLY 1.3 10 ms Unused 
Select Link/Unlink
•You are now in the Pre-Crossover Delay module. The arrow (in correspondence with the A and B indicators indicate which module block is currently selected. Rotate the DATA wheel to select Delay type and time. Pressing and then rotating the DATA wheel lets you link or unlink the A and B modules. Note that the same Effect types must selected to link. Use the PREV PG and NEXT PG buttons to move through A and B, and then to the next module screen which will appear something like this:
•You are now in the Crossover module. The arrow (in correspondence with the with the A and B indicators indicate which module block is currently selected. Rotate the DATA wheel to select Crossover type. Pressing and then rotating the DATA wheel lets you select the route path. You can route either Input A, Input B or the summed Input A+B to any mono input crossover. A stereo crossover can only have A and B routed to its two inputs.Use the PREV PG and NEXT PG buttons to move through A and B, Outputs 1-6 and then to the next mod- ule screen which will appear something like this:
®
Select Link/Unlink
N 
A F 
C 
B
A D 
B
Select
2 2
3 4 A A
5 6