Zone Controller Wiring
The DriveRack 260 Zone Controllers, (ZC-1, ZC-2, ZC-3, ZC-4) can be wired serially or in par- allel. To wire in series each Zone Controller must have an identification or zone number cho- sen using the DIP switches on the side of the controller (see diagram A). Each controller must have a unique number chosen although there may be multiple Zone Controllers controlling a single zone, or a single Zone Controller that controls multiple outputs. The Zone Controllers can then be wired together and connected to the DriveRack 260 (see diagram B).
The Zone Controllers may also be wired in parallel with the use of the ZC-BOB. To wire in parallel (home run cabling), each controller must have a unique identification or number cho- sen using the DIP switches on the rear of the panel (see diagram A). To wire in parallel, each controller must be wired into a port of the ZC-BOB with a connecting wire going to the DriveRack 260 (see diagram C).
Diagram A
Diagram B
ID# 1 | ID# 4 | |
80-1342-A | 80-1342-A | |
UL-650 | UL-650 | |
0 | 0 | |
IEC60065 | IEC60065 | 18 W A TTS |
RJ45 | CONNECTONLYTO | CONTROZONELLER | IN PUT . | RJ45 | CONNECTONLYTO | CONTROZONELLER | IN PUT . | Use only with a 250V fuse | | |
Employer uniquem entavao | POW ER | |
| | | | | | | | un fusible de 250V | | |
| | | | | | | | | 100V -120V | 50/60H z |
A HARM AN INTERNA | TIONAL |
COM P ANY SAL T LAKE | CITY ,U TA H |
| M ADE IN USA |
M ODEL | DriveRack TM 260 |
COM PLETE | EQ & LOUDSPEAKER |
M ANAGEM ENT SYSTEM |
| | | | | | |
| | | | | | |
| | | | | | |
