MEDIA TYPE | GUIDELINES |
|
|
Preprinted | • Letterhead must be printed with |
paper | that will not melt, vaporize, or release hazardous |
| emissions when subjected to the printer’s fusing |
| temperature for 0.1 second. Check your printer’s |
| specification to know the fusing temperature, see |
| "General specifications" on page 72. |
| • Letterhead ink must be |
| not adversely affect printer rollers. |
| • Forms and letterhead should be sealed in a |
| |
| storage. |
| • Before you load preprinted paper, such as forms |
| and letterhead, verify that the ink on the paper is |
| dry. During the fusing process, wet ink can come off |
| preprinted paper, reducing print quality. |
|
|
Using photographic paper or coated paper may cause problems, requiring repairs. Such repairs are not covered by Dell’s warranty or service agreements.
CHANGING THE SIZE OF THE PAPER IN THE PAPER TRAY
To load longer sizes of paper, such as
To change the tray 1 size to other size, you must adjust the paper length guide properly.
1.Pull the tray 1 out of the printer. Open the paper cover and remove paper from the tray 1 if necessary.
2.Pressing and unlatching the guide lock in the top of the tray, pull the tray out manually.
3.Load paper into the tray.
4.Slide the paper length guide until it lightly touches the end of the paper stack. Squeeze the paper width guide and slide it to the edge of the paper stack without causing it to bend.
For paper smaller than
If the paper that you need to print is shorter than length 222 mm
(8.74 inches), press and unlatch the guide lock in the tray, push the tray in manually. Adjust the paper length guide and paper width guide.
• Do not push the paper width guides far enough to cause the materials to warp.
•If you do not adjust the paper width guides, it may cause paper jams.
5.Close the paper cover.
Loading originals and print media 27
