Back to Contents Page
Power Supply
Dell™ OptiPlex™ 320 User's Guide
Replacing the Power Supply
DC Power Connectors
Replacing the Power Supply
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
1.Follow the procedures in Before You Begin.
2.Disconnect the DC power cables from the system board and the drives.
Note the routing of the DC power cables underneath the tabs in the computer chassis as you remove them from the system board and drives. You must route these cables properly when you replace them to prevent their being pinched or crimped.
3.Remove the two screws that attach the power supply to the back of the computer chassis.
4.Remove the CD/DVD drive and carefully set it aside (see CD/DVD Drive).
5.Press the release button located on the floor of the computer chassis.
1release button
2power supply
3screws (2)
4AC power connector
6.Slide the power supply toward the front of the computer by approximately 1 inch.
7.Lift the power supply up and out of the computer.
8.Slide the replacement power supply into place.
9.Replace the screws that secure the power supply to the back of the computer chassis.
10.Reconnect the DC power cables.
