Dell 755 manual Removing the Chassis Intrusion Switch

Removing the Chassis Intrusion Switch

1Follow the procedures in "Before You Begin" on page 21.

2Remove the computer cover (see "Removing the Computer Cover" on page 232).

3Disconnect the chassis intrusion switch cable from the system board by using two fingers to squeeze the release mechanism on one side of the connector as you pull to disconnect the cable connector.

4Slide the chassis intrusion switch out of its slot in the metal bracket, and then push it down through the square hole in the bracket to remove the switch and its attached cable from the computer.

NOTE: You may feel a slight resistance as you slide the switch out of the slot.

Replacing the Chassis Intrusion Switch

1Gently insert the switch from underneath the metal bracket into the square hole in the bracket, and then slide the chassis intrusion switch into its slot until you feel it snap securely into place.

2Reconnect the cable to the system board.

3Replace the computer cover (see "Replacing the Computer Cover" on page 317).

4If you are using a computer stand, attach it to the computer.

234

Ultra Small Form Factor Computer