Removing a Floppy Drive

1Follow the procedures in "Before You Begin" on page 21.

2Remove the computer cover (see "Removing the Computer Cover" on page 90).

NOTE: Since the following steps do not require the complete removal of the optical drive, it is not necessary to disconnect the cables connecting the optical drive.

3Remove the optical drive (if one exists) and carefully set it aside (see "Removing an Optical Drive" on page 131).

NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the cable connectors.

4Pull up on the drive-release latch and slide the floppy drive the back of the computer. Then, lift up to remove the drive from the computer.

12

1drive release latch

2floppy drive

5Disconnect the power and data cables from the back of the floppy drive.

6If you are not replacing the floppy drive or media card reader at this time, install the floppy drive inserts (see "Replacing Drive Inserts" on page 131). Contact Dell if you need a drive bay insert.

Drives

135

Page 135
Image 135
Dell 755 manual 135