4Remove the filler bracket (if applicable).

NOTE: See the documentation that came with the PS/2 serial port adapter for information on configuring the adapter, making internal connections, or customizing it for your computer.

5Align the PS/2 serial-port adapter bracket in the retention slot and press down firmly. Ensure that the adapter is fully seated in the slot.

 

2

1

3

 

4

1

card fully seated

2

card not fully seated

3

bracket within slot

4

bracket caught outside of slot

Before you close the card retention mechanism, ensure that:

The tops of all adapters and filler brackets are flush with the alignment bar.

The notch in the top of the adapter or filler bracket fits around the alignment guide.

6Close the card retention latch and gently press until it snaps into place.

NOTICE: Do not route cables over any installed cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage to the equipment.

7Connect the adapter cable to the serial port adapter connector (SERIAL2) on the system board (see "System Board Components" on page 32 for connector locations).

48

Cards

Page 48
Image 48
Dell 755 manual Card fully seated Card not fully seated Bracket within slot