Dell 755 manual Media card reader Drive release latch

3Remove the drive panel by sliding the drive release latch downward to open the panel, and then remove it from the hinges.

4Disconnect the cable from the back of the media card reader.

2

1

1 media card reader 2 drive release latch

5Grasp the sliding plate lever and slide it towards the bottom of the computer until the drive panel snaps open; while holding the lever in place, slide the media card reader out of the computer.

Installing the Media Card Reader

1If you are replacing a media card reader, remove the shoulder screws from the existing drive and attach the screws to the replacement media card reader.

NOTE: If you are replacing an existing floppy drive with a media card reader, ensure you disable the floppy before installing the media card reader. Boot your computer and enter system setup (see "Entering System Setup" on page 280). Use the Diskette Drive option to disable the floppy drive. Follow instructions in "Removing the Floppy Drive" on page 64.

2If you are installing a new media card reader, remove the drive-panel insert for the 3.5-inch drive bay, remove the shoulder screws from the inside of the drive-panel insert and attach the screws to the new drive.

Drives

67