Steps
1.Fold the PPID label around the cable.
2.Push the cable until the cable passes completely through the channel.
CAUTION: To prevent damage to the I/O cable, you must release the locking tab before removing or installing the I/O cable from the connector on the
3.If locked, rotate the locking tab on the I/O cable connector clockwise 90 degrees to release the lock.
4.Connect the I/O panel cable to the connector on the
5.Rotate the locking tab on the I/O cable connector counter clockwise 90 degrees to secure the lock.
6.Tighten the screws to secure the control panel to the chassis.
NOTE: You must route the cable properly to prevent it from being pinched or crimped.
Next steps
Follow the procedure listed in After working inside your system.
179
