Menu Item

Description

Port I

Sets the drive type of the selected device. For Embedded SATA settings in ATA

 

mode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOS

 

support.

 

For AHCI mode or RAID mode, BIOS always enables support.

Model

Displays the drive model of the selected device.

Drive Type

Displays the type of drive attached to the SATA port.

Capacity

Displays the total capacity of the hard drive. The field is undefined for removable

 

media devices such as optical drives.

Port J

Sets the drive type of the selected device. For Embedded SATA settings in ATA

 

mode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOS

 

support.

 

For AHCI mode or RAID mode, BIOS always enables support.

Model

Displays the drive model of the selected device.

Drive Type

Displays the type of drive attached to the SATA port.

Capacity

Displays the total capacity of the hard drive. The field is undefined for removable

 

media devices such as optical drives.

Boot Settings screen details

You can use the Boot Settings screen to set the Boot mode to either BIOS or UEFI. It also allows you to specify the boot order.

You can view the Boot Settings screen by clicking System Setup Main Menu System BIOS Boot Settings.

The Boot Settings screen details are explained as follows:

Example

 

Menu Item

Description

Boot Mode

Enables you to set the boot mode of the system.

 

CAUTION: Switching the boot mode may prevent the system from booting if

 

the operating system is not installed in the same boot mode.

 

NOTE: Setting this field to UEFI disables BIOS Boot Settings menu. Setting this

 

field to BIOS disables the UEFI Boot Settings menu.

 

If the operating system supports UEFI, you can set this option to UEFI. Setting this

 

field to BIOS allows compatibility with non-UEFI operating systems. By default, the

 

Boot Mode option is set to BIOS.

Boot Sequence

Enables or disables the boot sequence retry feature. If this field is enabled and the

Retry

system fails to boot, the system reattempts the boot sequence after 30 seconds. By

 

default, the Boot Sequence Retry option is set to Enabled.

Hard Disk Failover

Specifies which devices in the Hard-Disk Drive Sequence are attempted in the

 

boot sequence. When the option is Disabled, only the first hard disk device in the

42

Page 42
Image 42
Dell R730xd owner manual Boot Settings screen details