Removing the hard-drive backplane (R730)
Prerequisites
1.Ensure that you read the Safety instructions.
2.Follow the procedure listed in Before working inside your system.
3.Remove the cooling shroud.
4.Remove the
5.Remove all hard drives.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: To prevent damage to the drives and backplane, you must remove the hard drives from the system before removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label them before removal so that you can replace them in the same locations.
Steps
1.Disconnect the SAS/SATA data, signal, and power cable(s) from the backplane.
2.Press the release tabs and lift the backplane upward and slide it toward the back of the chassis.
Figure 71. Removing and installing the 2.5 inch (x16) SAS/SATA backplane—PowerEdge R730
1. | 2. backplane signal cable |
145
