Chapter 3 Creating and Editing Screens
Revision May, 2010 3-105
Property Description of Set Constant Buttons
Trigger
Trigger Type
The user can use this setting to trigger the designated controller
address to be ON before or after writing the setting value. Please
note that this function can only trigger the controller address to be
ON. If the controller address needs to be triggered again, the user
should set the address to be OFF manually.
Data Length
There are 16bits Word and 32bits Double Word two
options.
Data Format
There are following data format provided:
Word/Double Word
1. BCD
2. Signed BCD
3. Signed Decimal
4. Unsigned Decimal
5. Hex
Detail Range
Const Value
Used to enter the constant value that the user wants
to write. After pressing OK button, HMI will examine
the value by referring to the selected data length
and data format.
User Security Level
Use this option to set the user priority for pressing this element.
Only the priority that is equal to or higher than the current setting
can use this element.
Set Low Security
Use this option to force the current priority to be the lowest after
the button is pressed. This can prevent the misoperation made by
the user (operator).
InterLock Address
InterLock Level
When InterLock Addre ss is set to be ON or OFF ( this is determined
by the property of “InterLock Level”), this button can be enabled.
Before Execute
Macro
If this option is set, when the user presses the button, the system
will execute the command of this macro first and then perform the
operation of this button. But, if the state of the button is not
triggered by pressing the button (via macro or external signal), the
command of this macro will not be executed.