Resetting the Receiver to Factory Defaults
5.If you want to continue, select the Yes option. The receiver now displays the System Diagnostic Tests screen containing further instructions.
6.Aim both remotes at the receiver. Press one button at a time on your DISH Network remote, while pressing the button to be taught on the universal learning remote at the same time. Repeat this process for each button you want to be taught to the learning remote.
Note: Any button on the DISH Network remote that is not used with your DISH Network receiver, will not teach the universal learning remote.
7.You can quit the teaching mode at any time by either of the two following methods:
•Press any front panel button on your receiver.
•Leave the receiver alone for at least three minutes.
8.The receiver again displays the blank System Diagnostic Tests screen. You can cancel out of this screen back to your original viewing screen.
Resetting the Receiver to Factory Defaults
Use these instructions if you want to reset the receiver to be the same as when it was shipped.
Note: Resetting the receiver to factory defaults discards all Favorite Lists except the All Chan and All Sub lists.
Note: If you have set any locks on the receiver, and the receiver is locked, these locks will be kept. If the receiver is unlocked, any such locks will be lost. You cannot reset the receiver to default settings to discard a password you have forgotten. Only the Customer Service Center can reset the receiver to bypass a receiver lock.
1. Press the MENU button.
Page 73
Page 73
