Reference Manual

00809-0100-4808, Rev CA June 2008

Rosemount 3051N

Message

 

Description

 

 

 

ROM checksum

 

Checksum of transmitter software has detected a fault. Return

error ON

 

to Rosemount Nuclear Instruments, Inc. for repair.

 

 

 

Save data from

 

Prompts user to press SAVE softkey to initiate a

device to

 

device-to-memory transfer.

configuration

 

 

memory

 

 

 

 

 

Saving data to

 

Data is being transferred from a device to configuration

configuration

 

memory.

memory.

 

 

 

 

 

Sending data to

 

Data is being transferred from configuration memory to a

device.

 

device.

 

 

 

Sensor board not

 

The sensor module electronics board is not initialized. Return

initialized ON

 

to Rosemount Nuclear Instruments, Inc. for repair.

 

 

 

There are write only

 

There are write-only variables which have not been set by the

variables which

 

user. These variables should be set or invalid values may be

have not been

 

sent to the device.

edited. Please edit

 

 

them.

 

 

 

 

 

There is unsent data.

 

Press YES to send unsent data and turn the HC off. Press NO

Send it before

 

to turn the HC off and lose the unsent data.

shutting off?

 

 

 

 

 

Too few data bytes

 

Command returns fewer data bytes than expected as

received

 

determined by the device description.

 

 

 

Transmitter Fault

 

Device returns a command response indicating a fault with the

 

 

connected device.

 

 

 

Units for <variable

 

The engineering units for this variable have been edited. Send

label> has changed.

 

engineering units to the device before editing this variable.

Unit must be sent

 

 

before editing, or

 

 

invalid data will be

 

 

sent.

 

 

 

 

 

Unsent data to

 

There is unsent data for a previously connected device which

online device. SEND

 

must be sent or thrown away before connecting to another

or LOSE data

 

device.

 

 

 

Upgrade 275

 

The communicator does not contain the most recent

software to access

 

Rosemount 3051N Device Descriptors (DDs). Select YES to

XMTR function.

 

communicate using the existing DDs. Select NO to abort

Continue with old

 

communication.

description?

 

 

 

 

 

Use up/down arrows

 

Gives direction to change the contrast of the HC display.

to change contrast.

 

 

Press DONE when

 

 

done.

 

 

 

 

 

A-17

Page 93
Image 93
Emerson manual Rosemount 3051N