Item | Settings (default in bold) |
|
|
GL Mode | LJ4GL2, GLlike |
|
|
Scale | Off, A0, A1, A2, A3 |
|
|
Origin | Corner, Center |
|
|
Pen | Pen0, Pen1, Pen2*, Pen3*, Pen4*, Pen5*, |
| Pen6* |
|
|
End | Butt, Square, Triangular, Round |
|
|
Join | Mitered, Miteredbeveled, Triangular, |
| Round, Beveled, None |
|
|
Pen 0 through 6 | 0.05 ... 0.35 ... 5.00 mm in |
| increments |
|
|
* Available only when GLlike is selected as the GL Mode.
Before you start printing in the GL/2 mode
You may need to change the following print options in your application, depending on your output needs. Check these settings to make sure they match the data you are trying to print.
Print Options | Settings |
|
|
Paper size | Printer’s paper size setting |
|
|
Driver (plotter | |
selection) |
|
|
|
Pen configuration | Pen thickness |
|
|
Plot origin | Center or Corner |
|
|
Orientation | GLlike offers landscape only LJ4GL2 offers |
| landscape and portrait |
|
|
If you need to configure the printer settings, first switch to the GL/2 emulation mode, then change the settings using the printer driver, or the control panel menus.
248Using the Control Panel