Chapter 2
Paper Handling
Using the Two-Tractor System
Your printer’s paper handling system consists of a front push tractor and a rear push tractor. Both tractors are easy to load and operate, and both accommodate a wide variety of paper types, including labels and
The printer automatically adjusts to the thickness of the paper loaded when the Platen gap setting is set to Auto in the SelecType mode. See “SelecType mode” on page 88 for details.
You can print on continuous paper from 3 inches (76.2 mm) to
16.5inches (419.1 mm) wide. Your printer senses the paper width automatically.
When using more than two types of paper, load the paper you use most often onto the front tractor. The front tractor, which is easier to reach, will be available for the paper you change more frequently.
Note:
❏Before using your paper, check that it matches the specifications described in this manual. See “Paper” on page 171 for details. Also make sure your paper has a straight edge.
❏If continuous paper is fed past the sprocket (on the last page, for example), the paper may not feed properly.
❏When the optional perforation cutter (#C81507X) is installed, the printable width is from 4 inches (101.6 mm) to 16 inches (406.4 mm).
2
2
2
2
2
2
2
2
2
2
2
2
Paper Handling | 11 |