1.Make sure that the printer is turned on.
2.Set the position for the settings listed below in the
Label base pos. Label top pos. Label length Label left pos. Label width
Base sheet PG (Base sheet PG position number)
Label paper PG (Label paper PG position number)
3.Make the settings in the SelecType mode as shown below.
Forms w/labels: | On |
Pge length front: | paper length when using the front |
| tractor |
Pge length rear: | paper length when using the rear |
| tractor |
After you finish printing, you can use the
2
2
2
2
2
2
2
2
2
2
2
2
Paper Handling | 31 |