The perforation cutter is installed and the printer does not feed continuous paper properly.
Cause | What to do |
|
|
The perforation cutter’s connector is not plugged securely into the printer.
Turn off the printer then check the perforation cutter connector.
The perforation cutter is installed and the paper is not cut properly.
Cause | What to do |
|
|
The printer driver setting is | Select the paper source you want to use |
not set correctly. | in the printer driver. |
|
|
You didn’t set the Auto cut | Set the Auto cut mode to On. However, |
mode. | any setting made in the driver overrides |
| the auto cut mode setting. |
|
|
You don’t set the page length | Set the Page length for Rear tractor or |
to match your paper. | Page length for Front tractor to match |
| your paper. |
Paper jams, does not feed smoothly.
Cause | What to do |
|
|
The perforation cutter is not correctly installed.
Remove the perforation cutter and then reinstall it, making sure the mounting notches and pins fit together properly. See “Installing the pull tractor” on page 135 for instructions.
120Problem Solver