8. Before printing, make sure the paper release lever is set to
the single-sheet position. Also set the paper thickness lever
to the appropriate position for the paper loaded in the
cut-sheet feeder, as described on page 3-6. In your printer
driver software, select your paper size from the Paper Size
list.
The cut-sheet f eeder loads pape r when you send da ta to the
printer. You can also load paper by pressing the
Load/Eject button.
Note:
❑If the platen turns without loading the paper, completely remove
the paper and then insert it all the way into the printer again.
❑If you need to adjust the position of the paper after it is loaded,
see “Adjusting the printing position” on page 3-38. To move and
save the loading position of the paper, use the SelecType
“T-Margin CSF” setting. For more information on SelecType
settings, see page 4-8.
❑When loading from the cut-sheet feeder in Cards and
Envelopes modes, SelecType “T-Margin CSF” setting value
should be automatically set to 4.2 mm or more.
Loading paper manually from the fron t pa per gu ide
The cut-sheet feeder’s single-sheet loading feature allows you
to switch to a different type or size of paper without replacing
the paper already in the cut-sheet f eeder or removing t he
feeder. Follow these steps:
1. Make sure that the paper release lever is in the single-sheet
position.
2. Push the front paper guid e extension all the way in.
3. Slide the right edge guide until it is aligned with the guide
mark on the front paper guide.
6
R
Maple Rev.D
A5 size Chapter 6
06/17/97 pass 0
Using Printer Options 6-9