Epson DLQ-3000+ The printer prints on (or too far away from) the perforation of your continuous paper., The printer does not eject your continuous paper properly., 8-14

The printer prints on (or too far away from) the perforation of
your continuous paper.
Cause What to do
The tear-off position is se t
incorrectly. Adjust the tear-off position using the
d
or
u button. See “Adjusting the
tear-off position” on page 3-39.
The paper size setting in your
application or the printer
driver may not match the size
of the paper you are using.
Check the paper size setting in your
application or the printer driver.
The printer’s page length
setting may not match th e
size of the paper you are
using.
Check the “Page Tractor” setting using
SelecType or the EPSON Remote!
utility. See “SelecType” on page 4-8, or
“Using the printer utilities” on page
2-22.
The printer does not eject your continuous paper properly.
Cause What to do
You may be trying to feed too
much paper backward. If you are using normal continuous paper, tear off the last printed page
and press the Load/Eject button to
feed the paper backward. If you are
using labels, tear off the paper entering
the printer, and then press the LF/FF
button to feed the labels forward.
Your paper may be too long
or too short. Make sure the page length of your paper is within the specified range. See
the continuous paper specifications on
page A-5.
The paper size setting in your
application or the printer
driver may not match the size
of the paper you are using.
Check the paper size setting in your
application or the printer driver.
LMaple Rev.D
A5 size Chapter 8
06/17/97 pass 0
8-14 Troubleshooting