SelecType Options

SUB CONFIG.

The submenus for the subconfiguration option are different in each printer mode. See Using the SUB CONFIG Option later in this chapter for information on using this option.

SYSTEM CONFIG.

This option includes these eight submenus:

FULL PRINT T-OFFSET 1-OFFSET MEMORY LEFT LOAD MACRO SAVE MACRO DELETE MACRO POWERON MACRO

Each submenu is explained below.

FULL PRINT

0

0 to 62

The default setting of 0 is sufficient for most uses of the printer, but printing complex pages may require an increase in the setting. If the message SET FULL PRINT appears on the display, increase this setting. The setting (any number from 0 through 62) times 20 is the number of kilobytes (K) reserved in RAM for page composition. For example, a setting of 5 reserves 100K. The following table shows the maximum setting necessary for each size of paper. The setting may be lower than the maximum, but it will never need to be higher.

4-16 SelecType