Reinstalling the tractor in the push position

If a tractor is installed in the pull position, you need to remove it

 

and install the paper tension unit as described on “Removing the

 

pull tractor” on page 2-24before using the push tractor.

2

To reinstall the tractor in the push position, follow these steps:

 

1.Make sure the printer is turned off.

2.Remove the paper guide by holding both edges and lifting it up.

3.Hook the tractor's hooks on the pins inside the printer and press down both ends of the tractor to make sure that it is firmly seated.

You are now ready to load continuous paper onto the push tractor. To remove the tractor, see “Removing the push tractor” on page 2-12.

Printing on Continuous Paper 2-13