9.Fit three holes on each side of the paper over the tractor pins on both sprockets. Then close the sprocket covers.
10.Slide the right sprocket to remove any slack in the paper, then
lock it in place by pushing the sprocket lock down. | 2 |
|
11.If you use the front slot, attach the front cover with the continuous paper positioned as shown below. Then close it.
12.If you use the rear slot, replace the paper guide and make sure the edge guides are together in the middle of the paper guide and lift the center section of the paper guide up and lay it flat.
13.Turn on the printer.
Printing on Continuous Paper