Ericsson Dialog 4425 Start the Phone Log On/Off, Reset the phone, Connect the required cables

Start the Phone – Log On/Off

Start the Phone – Log On/Off

All system settings for your IP phone must be set by the system administrator before you can use the phone.

Connect the required cables.

See section “Installation” on page 132.

Note: Depending on the settings in your network and telephone system, the start up procedure may be different from phone to phone. Check the display on your phone and read the required sections in this chapter to continue with the start up procedure.

When this is done, and the phone is connected to the local network (LAN), your phone starts the start-up procedure automatically when connected to the mains.

Notes:

The phone does not work during a power failure. After a power failure the phone will restart automatically. However, when a password is requested, you must log on before the phone can be used again.

	Reset the phone
	If your phone does not work properly, you can use the following
	procedure to reset the phone. This procedure will also clear the
í É #	Call list. After the procedure you must log on again to use the
	phone.
	phone.
	Press simultaneously for at least one second to reset the

BusinessPhone – Ericsson Dialog 4425 IP Vision 19