N.O.: Normal Open contact.

N.C.: Normal Closed contact.

Network Alarm: Check box to send out a network alarm to client PC when motion occurs. (requires PowerCon software and setting up Alarm Server in Network Setup menu)

Active Camera: This field is for associating and alarm trigger with a specific camera. For example if you had an external motion detector near camera four you would set this option to “4”. The alarm will be associated with this camera for optional full screen display, event logging, and PTZ preset activation.

PTZ Preset: Select PTZ Preset from “1” to “255”. If the Active Camera is a PTZ speed dome, the alarm will move the camera to the specified preset position for event recording. Click “On” to confirm selection, “Off” to cancel selection. When “ON” a sub-menu is displayed for choosing the desired PTZ preset number.

Alarm Output: This will transmit a signal through the alarm output. It can be set to either “NONE” (not active) or “1” (active).

Output Type: Output action when alarm is triggered.

Timeout: Alarm output lasts for the set time duration.

Permanent: Alarm will remain active until user presses the “Enter” key or resets the alarm remotely.

Transparent: Alarm output remains as long as the alarm input is active.

Trans+Timeout: Alarm output continues until event ends, then continues for the set time duration.

Timeout Duration: Time duration selectable from 1 to 150 seconds.

Apply To: This button can be used to copy the alarm settings to other cameras. Select which cameras you wish to copy to. "Select All" selects all cameras, “Unselect All” deselects all cameras. Click “OK” to copy the settings or "Cancel" to exit without copying.

46

Page 54
Image 54
EverFocus ECOR264-4D1, ECOR264-8F1, ECOR264-8D1, ECOR264-4F1 user manual