Extron electronic MAV Plus Series, Ultra Series Operation, cont’d, Reset Mode Comparison/Summary

Operation, cont’d

Reset Mode Comparison/Summary

Mode	Activation		Result	Purpose/Notes
1	Hold down the recessed Reset button	The switcher reverts to the factory default		Use mode 1 to revert
	while applying power to the switcher.	firmware. Event scripting will not start if the		to the factory default
	N After a mode 1 reset is	switcher is powered on in this mode. All user files		firmware version if
		and settings (drivers, adjustments, IP settings, etc)		incompatibility issues
	performed, update the
		are maintained.		arise with user-loaded
	switcher’s firmware to the
		N If you do not want to update firmware, or		firmware.
	latest version. Do not operate
	the switcher firmware version		you performed a mode 1 reset by mistake,
	that results from the mode		cycle power to the switcher to return to the
	1 reset. If you want to use		firmware version that was running before
	the factory default firmware,		the mode 1 reset. Use the 0Q SIS command
	you must upload that version		to confirm that the factory default firmware
	again. See chapter 5, “Matrix		is no longer running (look for the asterisk
	Software”, for details on		[*] following the version number.
	uploading firmware.
3	Hold down the Reset button for about	Mode 3 turns events on or off. During resetting,		Mode 3 is useful for
	3 seconds, until the Reset LED blinks	the Reset LED flashes 2 times if events are starting,		troubleshooting.
	once, then press Reset momentarily	3 times if events are stopping.
	(<1 second) within 1 second.
4	Hold down the Reset button for	Mode 4:		Mode 4 enables you
	about 6 seconds, until the Reset LED	•	Enables ARP capability.	to set IP address
	blinks twice (once at 3 seconds and	• Sets the IP address to the factory default.		information using ARP
	again at 6 seconds). Then press Reset	• Sets the subnet address to the factory default.		and the MAC address.
	momentarily (<1 second) within 1	• Sets the gateway address to the factory default.
	second.	• Sets port mapping to the factory default.
		•	Turns DHCP off.
		•	Turn events off.
		The Reset LED flashes four times in quick
		succession during the reset.
5	Hold down the Reset button for	Mode 5 performs a complete reset to factory		Mode 5 is useful if
	about 9 seconds, until the Reset LED	defaults (with the exception of the firmware):		you want to start over
	blinks three times (once at 3 seconds,	• Does everything mode 4 does.		with configuration and
	again at 6 seconds, and then again	• Resets almost all real time adjustments:		uploading and also to
	at 9 seconds). Then press Reset		clears all ties and presets, clears all audio or	replace events.
	momentarily (<1 second) within 1		RS-232 mutes, clears all I/O grouping, clears
	second.		all RGB delay settings to zero, and clears all
			input and output audio settings.

N Mode 5 reset clears most	• Resets all IP options.
adjustments. To save these
	• Removes/clears all files for the switcher.
settings, use the Windows-
	The reset LED flashes four times in quick
based Matrix Switchers
	succession during the reset.
Control Program and the
File > Save MATRIX
settings as... selection before
you perform this reset (See
chapter 5, “Matrix Software”).

For different reset levels, press and hold the button while the switcher is running or press and hold the button while you apply power to the switcher.

3-56 CrossPoint / MAV Matrix Switchers • Operation