Extron electronic MAV Plus Series, Ultra Series manual Operation, cont’d, Example 7 Saving a preset

Operation, cont’d

Example 7: Saving a preset

In the following example, the current configuration is saved as a preset. The steps show the front panel indications that result from your action.

1. Press and release the Esc button (figure 3-43).

Press the Esc button to clear all selections.

C O N T R O L

ENTER PRESET VIEW ESC

The button flashes once.

Figure 3-43 — Clear all selections

2. Press and hold the Preset button for approximately 2 seconds until it blinks (figure 3-44).

Press and hold the Preset button until it blinks.

PRESET		PRESET
	2 seconds	All input buttons with assigned
		presets light red.

If you then save the configuration to a lit preset number, the configuration data at that preset location will be overwritten.

Red

(Preset Assigned)

1	2	3	15 16	I
				N
				P
				U
17	18	19	31 32	ST

Unlit

(No Preset Assigned)

Figure 3-44 — Enter Save Preset mode

3. Press and release the input or output button for the desired preset (figure 3-45).

C O N T R O L

Press and release the Input 1 button.

•The button blinks red to indicate that this preset number is selected but not saved.

1	2	3	4	5	6	7	8	15 16	I
									N
									P
									U
17	18	19	20	21	22	23	24	31 32	ST

ENTER PRESET VIEW ESC

•The Enter button blinks to indicate the need to save the preset.

•The Preset button continues to blink.

Figure 3-45 — Select the preset

NFigure 3-42 on page 3-31 shows the presets associated with the various input and output buttons for all three front panel configurations.

3-32 CrossPoint / MAV Matrix Switchers • Operation