Extron electronic MAV Plus Series, Ultra Series manual Table of Contents, cont’d

Table of Contents, cont’d

Creating a configuration	3-13
Example 1: Creating a set of video and audio ties	3-14
Example 2: Adding a tie to a set of video and audio ties	3-16
Example 3: Removing a tie from a set of video and audio ties	3-18
Viewing a configuration	3-20
Example 4: Viewing video and audio, audio only, and video only ties	3-21
I/O grouping	3-24
Example 5: Grouping inputs and outputs	3-26
Setting RGB delay (CrossPoint switchers)	3-28
Example 6: Setting the RGB delay for an output	3-29
Using presets	3-31
Example 7: Saving a preset	3-32
Example 8: Recalling a preset	3-33
Muting and unmuting video and/or audio outputs	3-35
Example 9: Muting and unmuting an audio/RS-232 output	3-36
Viewing and adjusting the input audio level (audio models)	3-38
Example 10: Viewing and adjusting an input audio level	3-39
Viewing and adjusting the output volume (audio models)	3-44
Reading the displayed volume	3-45
Example 11: Viewing and adjusting an output volume level	3-48
Setting the front panel locks (Executive modes)	3-52
Selecting Lock mode 2 or toggling between mode 2 and mode 0	3-52
Selecting Lock mode 2 or toggling between mode 2 and mode 1	3-53
Performing a system reset from the front panel	3-53
Background illumination	3-54
Selecting the rear panel Remote port protocol and baud rate	3-54

Rear Panel Operations	3-55
Performing soft system resets (resets 3, 4, and 5)	3-57
Performing a hard reset	3-58
Optimizing the Audio (Audio Models)	3-59
Troubleshooting	3-59
General checks	3-59
Plasma display S-video problem (CrossPoint switchers)	3-59
Configuration Worksheets	3-60
Worksheet example 1: System equipment	3-60
Worksheet example 2: Daily configuration	3-61
Worksheet example 3: Test configuration	3-62
32-button switchers configuration worksheet	3-63
16-button switchers configuration worksheet	3-65

iiCrossPoint / MAV Matrix Switchers • Table of Contents