Extron electronic MAV Plus Series Setting RGB delay CrossPoint switchers\⤀, Operation, cont’d

Operation, cont’d

7. Simultaneously press and release the RGBHV (CrossPoint switchers) or Video (MAV Plus switchers) button and Audio button (figure 3-36). The switcher exits I/O Group mode.

NAs an alternative, if you do not push any front panel buttons for approximately 30 seconds, the front panel times out and the switcher exits I/O Group mode.

•Group 1 consists of inputs 1 through 4 and outputs 1 through 4.

•Group 2 consists of inputs 5 through 8 and outputs 5 through 8.

I / O

VIDEO AUDIO

Press and release both buttons.

Figure 3-36 — Deselect I/O Group mode

Setting RGB delay (CrossPoint switchers\⤀

The CrossPoint 450 Plus and CrossPoint Ultra switchers can briefly blank the RGB (video) output while it switches to the new input’s sync source, and then switches the RGB signals. This allows a brief delay for the display to adjust to the selected input’s sync timing before displaying the new picture, which will appear without glitches. RGB delay, also known as Triple-Action Switching or video mute switching, is user selectable from 0 to 5 seconds, in half-second increments.

The RGB delay interval can be set on the front panel or by using either serial port or the Ethernet port and either the SIS, Windows control program, or HTML pages (see chapter 4, “Programmer’s Guide”, chapter 5, “Matrix Software”, and chapter 6, “HTML operation”. Specify the RGB delay interval for a specific output on the front panel as follows:

NRGB delay is protected when front panel lock mode 2 is selected. You can view the delay in lock mode 2, but not change it from the front panel. See “Setting the front panel Locks (Executive modes)” on page 3-52.

1. Press the Esc button to clear any input buttons, output buttons, or control buttons that may be lit.

2. To enter RGB Delay mode, press and hold the RGBHV button until the button begins to blink green, then release the button.

3. Press and release an output button to select an output. Each lit input button, from Input 1 through Input 10, indicates a half second of RGB delay interval for the selected output.

4. Press and release the Esc (>) and View (<) buttons to increase and decrease the interval.

5. Press and release the RGBHV button to exit the RGB Delay mode. The RGBHV button stops blinking.

N• Pressing the Enter or Preset button also exits RGB Delay mode. Pressing the Preset button changes to Recall Preset mode.

•The RGB interval for each output is stored in non-volatile memory. When power is removed and restored, the delay settings are retained.

•Exiting RGB Delay mode by pressing the RGBHV button always returns the I/O configuration to audio only selected for configuration.

3-28 CrossPoint / MAV Matrix Switchers • Operation