Extron electronic MLC 62 IR D manual Rear Panel Features on MLC 62 RS EU and MLC 62 RS MK Only

Rear Panel Features on MLC 62 RS EU and MLC 62 RS MK Only

The items listed in this section are located on the rear panel of the MLC 62 RS EU and the MLC 62 RS MK only. On the MLC D models, these items are on the front panel, behind the wallplate (see “Rear Panel Features” for the descriptions of features A through F).

9

8

1	2	C	Tx/	Tx
RELAYS			IR	PORT A
			PORT B
	N/O		IR/ S	RS-232

2 1

TINPU	CONFIG	xma A 4.0
		V 12
LDIGITA	HOST/	PW	R
R		+
1	Rx Tx

7

Figure 12. Features on MLC 62 RS EU and the MLC 62 RS MK Rear Panels Only

GReset LED — Indicates the status of a reset in progress.

HReset button — Press this reset button to initiate factory firmware or configuration resets (see “Resetting the MLC Using the Reset Button,” later in this section).

IDIP switches — Reserved for future use

MLC 64 RS VC D Volume Control Module Rear Panel

The MLC 64 RS VC rear panel is illustrated below. The MLC module rear panel (right side as you view it from the back) has the same features as that of the MLC 62 RS D (see figure 11, earlier in this section).

GND VOL 10V

10

Figure 13. MLC 64 RS VC D Rear Panel VCM Features

JVolume control module connector (MLC 64 RS VC D only) — Connect an Extron amplifier to this 3-pole, 3.5 mm captive screw connector to enable volume and mute control by the MLC (see “Wiring the Volume Control Module (MLC 64 RS VC D

Only),” later in this section).

NOTE: Use only Extron amplifiers with the MLC 64 RS VC D.

MLC 60 Series MediaLink Controllers • Features, Installation, and Operation 16