Fluke 5020A user manual SYSTemPASSwordALARm?, SYSTemPASSwordALARm bool, SYSTemPASSwordCDISable

5020A

Users Manual

SYSTem:PASSword:ALARm?

Returns the state of the alarm settings password protection. Example: SYST:PASS:ALAR?

Response: 0

A value of 1 is returned if the alarm settings are password protected; otherwise a value of 0 is returned.

SYSTem:PASSword:ALARm <bool>

Sets the state of the alarm settings password. Example: SYST:PASS:ALAR 1

The <bool> parameter turns the alarm settings password protection on (1 or ON) or off (0 or OFF). This command is password protected. Commands protected with this setting are any of the ALAR… commands

SYSTem:PASSword:CDISable

Disables access to password-protected settings. Example: SYST:PASS:CDIS

Sending this command prevents the user from changing any password-protected settings.

SYSTem:PASSword:CENable <pass>

Enables access to password protected settings. Example: SYST:PASS:CEN 1234

The <pass> parameter must match the current system password. This command must be sent to allow the user to change and password-protected settings. After sending this command, use the SYST:PASS:CEN:STAT? command to verify access.

SYSTem:PASSword:CENable:STATe?

Returns the current password protection state. Example: SYST:PASS:CEN:STAT? Response: 0

The response is either 0 (disabled) or 1 (enabled). A response of 0 indicates password- protected settings cannot be changed. A response of 1 indicates the password was successfully entered and password-protected settings can be changed.

SYSTem:PASSword:NEW <pass>DEF

Sets the current system password to a new password. Example: SYST:PASS:NEW 1212

The <pass> parameter must be a 4-digit number (0000 to 9999). Specifying the DEF parameter resets the password to the default password (5020A). This command is password protected.

6-42