8

Press [Mode 1] and [Mode 2] at a time to

 

see Screen 4. The settings are stored to

 

EEPROM.

9

When you close the setup mode, press

 

[Stop]. Then the readable screen is

 

displayed.

 

 

Mode

Details

 

ON/OFF “OFF” is default setting.

1“1” is default setting.

This mode is used when the batch of paper which length are same are scanned.

When the paper which tears and wrincled are scanned, Scanner may mistake it also.

2This mode is used when the batch of paper which length and thickness are same are scanned.

However, when the thin papers are scanned, Scanner may mistake to detect the Double-feed rarely.

In case of this, please test to scan the thin papers in advance.

B3.2 Setting IPC-2 pre-set mode

When you set the using of IPC-2 pre-set mode, you must set as follows.

<< SETUP MODE >>

IPC-2 SET

Screen 8

IPC-2 SET

No

Screen 9

IPC-2 SET

X

Screen 10

10 At Screen 2, press [Mode 1] twice to go to the IPC-2 SET screen. (Screen 8)

11 Press [Mode 2] to see Screen 9 or 10. If “No” is displayed, IPC-2 pre-set mode is not used. If pattern number (“1”-”5") is displayed, IPC-2 pre-set mode is used. “No” or number status flips each time you press [Mode 1]. (The default setting is “No”.)

12 If you press the [Mode 2] at Screen 9, you return to Screen 8. The setting is stored to EEPROM. If you press the [Mode 2] at Screen 10, you go to Screen 12.

B-4

M3099GX/GH OEM Manual