Furuno 1964C-BB, GD-1920C-BB, 1954C-BB, 1944C-BB, 1934C-BB Inserting a Chart Card, Processor unit

1. OPERATIONAL OVERVIEW

1.2Inserting a Chart Card

Your unit reads SD cards, in the following formats: Navionics GOLD charts or C-MAP NT+/ NT MAX charts, depending on the type of processor unit you have. Insert the appropriate chart card for your area as follows:

1. Open the chart drive.

Chart drive

Processor unit

2.Insert desired chart label side up, before turning on the power.

3.Close the lid.

To remove chart card, follow the steps shown below.

1.Press the MENU key to show the menu.

2.Press the SHOW/HIDE key.

3.Open the chart drive lid, and then push the card once and then pull it out.

Note 1: Do not remove a card while the chart is being drawn. This may cause the equipment to freeze.

Note 2: Do not insert or remove a card while the power is on. This may cause the equipment to freeze.

Note 3: For multiple processor units, do not use the same chart card type in more than one processor unit.

Note 4: Remove the card with care; rough handling can damage the card and destroy its contents.

1-3