Furuno 1834C-BB, GD-1920C-BB, 1954C-BB, 1964C-BB manual Nav Data Display Setup, Nav data setup screen

7. CUSTOMIZING YOUR UNIT

2.Adjust the Trackball upward or downward to select Decca chain number.

3.Roll the Trackball rightward to show the display below, to enable selection of station pair.

CHAIN STATION PAIR

		▲
01	▼	R-G
		▼
S BALTIC

Decca chain and station pair window

4.Adjust the Trackball upward or downward to select station pair (R: red, G: green and P: purple).

5.Press the C: ENTER soft key to register your selection.

6.If necessary, you may enter position offset to refine Decca position. Select (CHAIN) CORRECTION 1 or CORRECTION 2, then press the A: EDIT soft key. Enter correction value with the Trackball and alphanumeric keys. Use the A: + < − −> - soft key to switch from plus to minus and vice versa. Press the C: ENTER soft key or push the ENTER knob.

7.Press the E: RETURN soft key twice.

8.Press the A: GENERAL SETUP soft key followed by the D: NEXT PAGE soft key.

9.Select “DECCA” from “TD DISPLAY” and “TD” from “POSITION DISPLAY.”

10.Press the MENU key twice to close the menu.

7.8Nav Data Display Setup

The nav data display shows various navigation data, fed from a navigator, network equipment, etc. You may select the data to display and where to display it as follows:

1.Press the MENU key to open the main menu.

2.Press the E: SYSTEM CONFIGURATION, C: SYSTEM SETUP, C: HOT PAGE & NAV

DISP SETUP and B: NAV DATA DISPLAY SETUP soft keys.

1	POSITION
2	WPT POS	3	SOG
4	STW	5	COG
6	BEARING	7	RANGE
8	DEPTH	9	TEMP

NAV DATA

A EDIT

E RETURN

Nav data setup screen

7-30