Furuno 1834C-BB, GD-1920C-BB Clearing Memories, Memory clear menu, Windows for clearing memory

8. MAINTENANCE, TROUBLESHOOTING

8.10 Clearing Memories

Your equipment has a memory for each of the plotter, radar and sounder sections. These memories can be cleared to restart operation with default settings.

The following data are not cleared:

Radar: Heading adjustment, timing adjustment, MBS level, tuning point, tuning indication (short, medium, long), video level, dead sector, antenna height, STC curve, antenna type, on time, tx time, Sounder: White marker, hue, signal level, TLL output, depth calibration, range.

1.Press the MENU key to open the menu.

2.Press the E: SYSTEM CONFIGURATION soft key.

3.Press the C: SYSTEM SETUP soft key.

4.Press the B: TEST & CLEAR soft key.

5.Press the D: MEMORY CLEAR soft key.

PROCESSOR UNIT	NO
GPS SENSOR	NO

NETWORK SOUNDER NO

MEMORY CLEAR

A EDIT

E RETURN

Memory clear menu

6.Use the Trackball to choose the memory to clear.

7.Press the A: EDIT soft key.

8.Use the Trackball to select YES, then press the C: ENTER soft key. One of the following displays appears depending on the selection made at step 6.

ALL SETTNGS EXCEPT SNDR ARE RESET TO DEFAULT. ARE YOU SURE? YES ... PUSH ENTER KNOB NO ... PUSH CLEAR KEY

BEGIN COLD START TO CLEAR GPS MEMORY. ARE YOU SURE?

YES ... PUSH ENTER KNOB NO ... PUSH CLEAR KEY

SOUNDER WILL BE

SET TO DEFAULT.

ARE YOU SURE?

YES ... PUSH ENTER KNOB NO ... PUSH CLEAR KEY

Processor Unit Clear GPS Receiver Clear Network Sounder Clear

Windows for clearing memory

9.Push the ENTER knob to clear the memory selected.

10.Press the MENU key to close the menu.

11.Turn the power off and on again.

Note: The message “SYSTEM HAS FAILED START UP TEST. PLEASE CONTACT A LOCAL FURUNO REPRESENTATIVE FOR REPAIR. PUSH ANY KEY TO CONTINUE.” may appear when powering on the processor unit immediately after clearing any memory. It is not an indication of malfunction. Press any key to continue operation.

8-13