Furuno 1954C-BB, GD-1920C-BB, 1964C-BB, 1944C-BB, 1934C-BB Outputting TLL Data, Target soft keys

2. RADAR OPERATION

2.21 Outputting TLL Data

Target position data can be output to units of the network and shown on their plotter screen with the TLL mark (X). This function requires position and heading data.

1.Operate the Trackball to place the cursor on the target whose position you wish to output.

2.If not displayed, press the HIDE/SHOW key to display the radar soft keys.

3.Press the D: TARGET soft key.

12/LP 3nm

H-UP

319. 9°M TARGET

A TRAIL

B TLLOUTPUT

C ACQ

D TARGET

INFO

E RETURN

+ 359.9 ˚R 11.70nm

Requires ARP circuit board

in Model 18x4-BB/19x4-BB series NavNet radar. Not shown otherwise.

TARGET soft keys

4.Press the B: TLL OUTPUT soft key to output target position data. The TLL mark

appears on the plotter screen at the target’s position the moment the B: TLL OUTPUT soft key was pressed. Further, that position is recorded as a waypoint on all NavNet units, under the youngest empty waypoint number on each NavNet unit.

5.Press the E: RETURN soft key to finish.

Note: The screen of the TLL recipient may be temporarily interrupted when receiving TLL from another NavNet unit. Press any key to restore normal operation.

2-21