Furuno GP-3300, GD-3300 manual Waypoint entry by cursor

4. Enter latitude.

Cancel entire line of data: Press the [CLR] key.

Change data: Place data input cursor on wrong data, and then reenter data.

Switch coordinates: [+] key, changes coordinate to North or East, [-] key, changes coordinate to South or West.

5.Place the data input cursor to the first digit of longitude and then enter longitude.

6.Enter comment, if desired.

Note: Waypoint comment can be entered on the Waypoint List. See 4.2 Entering a Waypoint Comment.

7.Press the [ENT] key.

Waypoint entry by cursor

1.Press the [WPT] key to display the REGISTER WAYPOINT menu.

REGISTER WAYPOINT

MODE	=	CURSOR
WPT NO.	=		−

L/L OS POS. R/B LIST

ENTER WAYPOINT NO., AND DESIGNATE WAYPOINT POSITION BY

USING CURSOR.+ : DISPLAY

− : NOT DISPLAY

Figure 4-3 REGISTER WAYPOINT menu

2.Select CURSOR from the MODE field, if it is not already se- lected.

3.Select WPT NO.

4.Enter waypoint number in two digits. If the waypoint number is 07, for example, press [0] and [7].

Note 1: If the waypoint number is already used, “(USED)” appears to alert you. You can enter a new number by pressing the [CLR] key, or overwrite the waypoint number by going to step 5.

Note 2: You can register a waypoint without entering waypoint number, in which case the unit automatically registers the waypoint in the youngest, unused waypoint. For example, if waypoints 01, 02, 04 and 05 are used when you enter a waypoint without designating waypoint number, the unit will automatically register that waypoint as waypoint number 03.

4-3