Furuno GP-3300, GD-3300 manual Setting destination waypoint by waypoint number

3.Place the cursor on latitude and longitude position desired for destination waypoint. Note that if you place cursor near a mark or a waypoint displayed, cursor position (destination waypoint) is pulled into the mark displayed.

4.Press the [ENT] key

Setting destination waypoint by waypoint number

1.Press the [FR/TO] key to display the DESTINATION SETTING menu.

DESTINATION SETTING

DEST = SET

MODE = CURSOR

CANCEL

WAYPOINT

ROUTE R/B

WPT NO. = 0 0 + − − + − − + − − + − − + − − + − − + − − +

+− − + − − + − − + − − + − − + − − + − − + −

ENTER WAYPOINT NO.

Figure 4-10 DESTINATION SETTING menu

2.Select WAYPOINT from the MODE field.

3.Select WPT NO.

4.Enter waypoint number(s) in two digits. If the waypoint number is 07, for example, press [0] and [7].

5.Press the [ENT] key.

Note: The message “DATA ERROR” appears on the display when the waypoint number entered is not registered.

Setting destination waypoint by range and bearing

1.Press the [ENT] key to display the DESTINATION SETTING menu.

2.Select R/B from the MODE field.

3.Select RANGE.

4.Enter range.

5.Select BEARING.

6.Enter bearing.

7.Press the [ENT] key twice.

4-9